Circuit-Projects.com Logo
  Search
  Search through schematics
       
Become a reader:
 
 


Circuit Diagrams

10W Audio Amplifier with Bass-Boost with NE5532 and TIP41

Print E-mail

10W Audio Amplifier with Bass-Boost with NE5532 and TIP41

Description:  

This design is based on the 18 Watt Audio Amplifier, and was developed mainly to satisfy the requests of correspondents unable to locate the TLE2141C chip. It uses the widespread NE5532 Dual IC but, obviously, its power output will be comprised in the 9.5 - 11.5W range, as the supply rails cannot exceed ±18V...

 

2N3055 Power Supply 50V/2A

Print E-mail

2N3055 Power Supply 50V/2A

Description: 

Many times we needed a stabilized, together regulated power supply and high relatively output voltage. These specifications him it cover our circuit. It 's a circuit that can give in his exit + 40V until + 60V 3A, with simultaneous stabilization. The materials that use is very simple and will not exist difficulties in the manufacture, is enough you are careful certain points. 1 ] For output voltages smaller of + 50V until + 40V, the Q1 is hot enough, so that it needs one big heatsink. 2]For output voltages bigger of + 50V up to + 70V, the stabilization is not satisfactory. Conclusion: ideal output voltage is + 45V until + 60V...

 

12V to 100V Power Supply for Low Current Applications

Print E-mail

12V to 100V Power Supply for Low Current Applications

 

Description: 

Here is a simple circuit for generating over 100 volts from a 12 volt source for powering low current devices and experiments. The two transistors may be 2N4401 and 2N4403 or similar for lower power applications or higher power devices for heavier loads. If more power is desired then lower the two 10 ohm emitter resistors to 3.3 ohms. When driving power transistors, more drive may be achieved by adding two more gates and resistors in parallel with the two output gates shown. Notice that the two driver gates are simply in parallel with 220 ohm current limit resistors in series with their outputs...

 

Flyback Driver Circuit with LM555 Timer

Print E-mail

Flyback Driver Circuit with LM555 Timer

 

Description: 

This is a good and fairly efficient flyback driver circuit. All parts can be obtained easily from Radio Shack, including the MOSFET. This circuit uses a 555 timer IC to pulse a 2N2222 with square wave at a frequency that is set by the capacitor and the potentiometers. The 2N2222 then drives the gate of the MOSFET and the MOSFET delivers the pulse to the ten turn winding on the flyback...

 
<< Start < Prev 1 2 3 4 5 6 7 8 9 10 Next > End >>

Results 33 - 36 of 57

Submit Your Project
You can share your own electronic circuit schematics/diagrams or projects with people from all around the world...
Please Click
Resistor Value Calculator
4 Band | 5 Band
B1
B2
B3
B4
Value:
Tolerance:
Circuit Categories
Home
Audio
Battery
Control
Metering
Power Supply
Radio Frequency
Miscellaneous
..................................................
Link Directory
Submit Circuit
Contact
Circuit Diagrams

Electronics-Lab
Visit for more electronics!
Embedds.com
Embedded projects from around the web.
MCU project everyday
Elecfree.com
Electronic Circuit Project Blog
Elecfree Blog
Latest Comments
10 LED VU Meter Proj...
1. how is it connected? what is the input?
Electronic Thermomet...
2. Is there anyway to have the the lights turn off and the temp goes up?
10 LED VU Meter Proj...
3. have a problem using one or lm324n a lm324 opamp?
12V DC to 220V AC - ...
4. I appriciate your work. U have done a gr8 job. Dear can u send me a diagram for same input...
LDR & LED Pair Smoke...
5. i want to the circuit of smoke detector
 






 
Electronic Circuit Projects
Circuit-Projects.com is licensed under a Creative Commons Attribution-No Derivative Works 3.0 License.

 
Powered by Joomla. The original Circuit-Projects.com theme is used.